CoreParts MMHP160-2GB modulo di memoria 1 x 2 GB DDR3 240-Pin DIMM ECC

The CoreParts MMHP160-2GB is a 2GB DDR3 memory module running at 1333 MHz with ECC support. Designed for PCs and servers, this single-module configuration increases system memory capacity while using original chip sets from certified suppliers. The module's green colour helps identify it in builds and matches other CoreParts components.

Advantages

ECC (error-correcting code) provides improved data integrity by detecting and correcting single-bit memory errors. The module follows standard DDR3 specifications at 1333 MHz, offering compatibility with systems that support DDR3 ECC memory. Supplied by certified manufacturers, the module uses original chip sets to match the performance of original RAM modules.

Suitable for

• Upgrading memory in ECC-capable servers
• Adding RAM to workstations that require error correction
• Replacing a faulty DDR3 2GB 1333MHz ECC module

Key specifications

• Capacity: 2 GB
• Type: DDR3
• Clock speed: 1333 MHz
• Features: ECC (error-correcting code)
• Colour: Green
• Weight: 0.05 kg
• Brand: MicroMemory
• MPN: MMHP160-2GB
• EAN: 5706998871435

How to use

Power off the computer and disconnect it from the mains. Open the case following the manufacturer's instructions and locate an available DDR3 ECC DIMM slot. Align the module with the slot notch and press down evenly until the retention clips click into place. Close the case, reconnect power, and boot the system. Verify that the BIOS/UEFI recognises the new 2GB module and that ECC is enabled if required by the platform.

Recommendations

Use this 2GB DDR3 1333MHz ECC module in systems that explicitly support DDR3 ECC memory. For optimal stability, install modules of the same size, speed and manufacturer where possible and consult the system or motherboard manual for supported configurations and maximum memory limits.