Distributore SAT Renkforce a 3 vie modello 11046c2E con passaggio DC per alimentazione LNB

The Renkforce SAT distributor 3-way model 11046c2E with DC pass for LNB power distribution is an indoor satellite signal splitter that divides a single satellite feed to up to three receivers while maintaining DC continuity for powering the LNB. It is designed for home and small-office installations where a single dish feed must be shared without altering the RF characteristics of the incoming signal. The built-in DC pass function allows one of the connected tuners or a central multiswitch to supply power to the LNB, reducing the need for separate power adaptors.

Advantages

This 3-way SAT distributor delivers even signal splitting across three outputs while preserving the original signal impedance and frequency range. The DC pass capability ensures uninterrupted LNB powering from a compatible receiver or central unit. Its compact indoor housing facilitates easy mounting and connection in equipment cabinets or behind entertainment centers. The device provides a straightforward, space-saving solution to distribute satellite signals without active electronics or additional power requirements for the splitter itself.

Suitable for

• Connecting one satellite dish to up to three set-top boxes or satellite receivers
• Small residential apartments and houses with multiple TVs
• Small office environments requiring shared satellite signal distribution
• Systems where one receiver or multiswitch must supply DC power to the LNB

Key specifications

• Splitter type: 3-way passive satellite signal distributor
• Frequency range: suitable for satellite IF bands (typical satellite reception ranges supported)
• Impedance: 75 ohm matching for standard coaxial satellite installations
• DC pass: present on input to allow LNB powering from a receiver or multiswitch
• Installation type: indoor mounting
• Connectors: F-type coaxial connectors (input and three outputs)

How to use

Install the distributor in a dry indoor location close to the satellite receiver(s) or central distribution point. Connect the incoming coaxial cable from the satellite dish to the distributor's input connector. Attach up to three coaxial cables to the output connectors and route them to each satellite receiver. Ensure at least one connected receiver or a central multiswitch is configured to provide DC power on the coaxial feed if the LNB requires powering through the splitter. Verify secure F-type connections and check each receiver for signal lock and quality.

Recommendations

Use high-quality 75 ohm coaxial cables and properly tightened F-type connectors to minimize signal loss. If signal levels are insufficient after splitting, consider using a distribution amplifier or a powered multiswitch for improved signal strength and multiple-user setups. Avoid outdoor installation; the unit is intended for indoor use only.