Kingston Server Premier - DDR4 - 16 GB - DIMM 288-PIN - 3200 MHz / PC4-25600 - CL22 - 1.2 V - registrata - parità - ECC

The Kingston KSM32RS4/16HDR is a 16 GB DDR4-3200 registered ECC memory module in a 288-pin DIMM form factor. It is built as 2G x 72-bit (1Rx4) and populated with FBGA components, with SPD programmed to JEDEC DDR4-3200 timings (22-22-22) at 1.2V. The module uses gold contact fingers and is intended for systems requiring error-correcting registered memory for improved data integrity.

Advantages

This Kingston memory module provides ECC (error-correcting code) functionality and registered (RDIMM) architecture to enhance data reliability in servers and workstations. Operating at 3200 MHz with CAS latency 22 and JEDEC-standard SPD, it offers predictable timing and system compatibility. The 288-pin DIMM form factor and standard 1.2V operation ensure broad hardware support.

Suitable for

• Servers and enterprise workstations requiring ECC registered memory
• Systems that support 288-pin DDR4 RDIMM modules
• Applications where data integrity and stability are important (databases, virtualization)

Key specifications

• Capacity: 16 GB
• Type: DDR4 SDRAM, registered with ECC (RDIMM)
• Speed: DDR4-3200 (3200 MHz)
• CAS latency: CL22 (22-22-22 JEDEC timing)
• Organization: 2G x 72-bit, 1Rx4
• Voltage: 1.2 V
• Form factor: 288-pin DIMM
• Manufacturer part number (MPN): KSM32RS4/16HDR
• EAN: 0740617308105

How to use

Power down the system and disconnect from mains before installing the DIMM. Align the module with the 288-pin DIMM slot on the motherboard or server board, ensuring the notch matches the slot key. Press evenly on both ends until the retention clips engage. After installation, power on the system and verify in firmware/BIOS that the module is detected and ECC/registered operation is enabled if required by the platform.

Recommendations

Install Kingston KSM32RS4/16HDR modules in matched pairs or per the motherboard/vendor memory population rules to ensure optimal performance and stability. Use in systems that explicitly support DDR4 RDIMM with ECC and operate at 1.2V. Follow server vendor guidelines for firmware settings and memory population to maintain reliability.