Modulo ricetrasmettitore di rete Origin SFP+ 10Gbps compatibile per apparecchiature Dell, interfaccia ottica/elettrica

Origin SFP+ 10Gbps compatible network transceiver module for Dell equipment, optical/electrical interface is a hot-pluggable SFP+ form factor transceiver designed for 10 Gigabit Ethernet links in Dell switches and servers. It provides a compact module that can be used to extend fiber or copper connections, replace faulty transceivers, or add 10GbE ports to support high-speed data transfer, virtualization and storage networking. The module is presented as compatible with Dell equipment and supports either optical or electrical interfaces depending on the specific port and cable used.

Advantages

This Origin SFP+ module offers a standard SFP+ footprint that simplifies installation and compatibility with Dell hardware. Its hot-pluggable design allows service replacement without powering down equipment. Support for both optical and electrical interfaces provides flexibility to connect short-range copper or longer-range fiber links. The module is intended to deliver predictable 10Gbps link speed suitable for data center, server and switch environments where consistent throughput is required.

Suitable for

• Adding 10 Gigabit Ethernet ports to Dell switches and servers
• Replacing faulty or damaged SFP+ transceivers in compatible Dell equipment
• Extending fiber or copper connections for storage, virtualization or high-throughput applications

Key specifications

• Form factor: SFP+
• Nominal link speed: 10 Gbps
• Interface support: optical and electrical (dependent on port and cable)
• Compatibility: designed for use with Dell networking and server equipment
• Hot-pluggable design for in-service replacement

How to use

Install the Origin SFP+ module into an appropriate SFP+ slot in a Dell switch or server until it latches. If using an optical connection, attach the compatible fiber patch cable and ensure correct connector type and polarity. If using an electrical connection, insert the correct SFP+ copper cable or direct attach cable. Monitor the host device interface status to confirm link negotiation at 10Gbps. Remove the module by releasing the latch and pulling it straight out when the device port is disabled or the equipment is powered down if required by your maintenance procedure.

Recommendations

Verify Dell device firmware and compatibility lists before deployment, choose the correct cable type for the required reach (fiber or copper/DAC), and handle the module with ESD precautions. Keep dust caps on unused optical ports and follow the equipment vendor's procedures for hot-swap operations.