Modulo di memoria CoreParts MMI9852/4GB 1 x 4 GB DDR3 240 pin DIMM ECC

The CoreParts DDR3 4GB 1333MHz ECC memory module (MMI9852/4GB) is a single 4 GB DDR3 RAM stick with ECC support and a clock speed of 1333 MHz. Designed as an alternative module using original chipsets from certified suppliers, this module aims to match the performance and reliability of original factory RAM. The module comes in green and is suitable for systems that require error-correcting memory for improved data integrity.

Advantages

This ECC DDR3 module provides error-correcting capability to detect and correct single-bit memory errors, improving system stability in memory-sensitive environments. With a standard 1333 MHz frequency and a 4 GB capacity, it offers a balance of performance and compatibility for older servers and workstations. The module uses original chip sets sourced from trusted suppliers to ensure consistent operation.

Suitable for

• Legacy servers and workstations that require DDR3 ECC memory
• Systems needing 4 GB DIMM upgrades for basic multitasking
• Environments where data integrity and stability are important

Key specifications

• Internal memory: 4 GB
• Memory type: DDR3
• Clock speed: 1333 MHz
• ECC: Yes
• Colour: Green
• MPN: MMI9852/4GB
• EAN: 5711045178665

How to use

Power down the computer and disconnect it from the mains. Open the case according to the manufacturer’s instructions, locate an empty compatible DIMM slot, and align the module with the slot keyed notch. Firmly press the module into place until the retention clips engage. Close the case, reconnect power, and start the system. Check the BIOS/UEFI to confirm the module is recognized and ECC is enabled if required.

Recommendations

Install this CoreParts DDR3 4GB 1333MHz ECC module in systems that support DDR3 ECC DIMMs. For best results, use modules of the same capacity and speed in matched channels and verify ECC settings in the system firmware.