Modulo sensore di vetro PCB per Lenovo Small Glass Synaptics 01YU091

Replacement PCB glass sensor module compatible with Lenovo Small Glass Synaptics 01YU091. This board contains the Synaptics touch and glass interface circuitry designed to restore touch functionality in compatible Lenovo devices. It is intended for repair and refurbishment tasks where the original glass sensor assembly is damaged, unresponsive, or needs replacement. The module matches the original-equivalent form and connector layout to facilitate integration without major modifications.

Advantages

The PCB glass sensor module provides the necessary touch controller and interface components to restore accurate touch detection and gesture recognition. Being an original-equivalent design, it preserves electrical and mechanical compatibility with supported Lenovo assemblies. The module simplifies repairs by offering a single-board replacement that reduces diagnosis time and avoids the need for multiple component-level fixes.

Suitable for

• Repair of Lenovo devices with Small Glass Synaptics touch assemblies
• Refurbishment projects requiring replacement of a damaged glass sensor board
• Technicians performing component-level restoration of touch functionality
• Quality-control testing and validation of touch interface performance after repair

Key specifications

• Function: touch/glass sensor interface board for Synaptics-based systems
• Compatibility: designed for Lenovo devices using the Small Glass Synaptics assembly
• Form factor: compact PCB matching original module footprint and connector layout
• Components: includes touch controller circuitry and supporting passive components
• Mounting: intended for direct replacement within the device housing where the original module is installed

How to use

Power off the device and disconnect any batteries or power sources before beginning. Access the internal assembly following the device service manual or manufacturer disassembly guide to avoid damage. Remove the damaged sensor board by disconnecting the flex cable and any mounting fasteners; then install the replacement PCB glass sensor module by aligning the board to the original mounting points and reconnecting the flex cable and fasteners. Reassemble the device and reattach power, then perform a touch calibration or system test to verify restored functionality.

Recommendations

Handle the replacement module using appropriate electrostatic discharge (ESD) precautions and use correct torque for fasteners. Verify compatibility with the specific Lenovo model before installation and follow official service documentation for safe disassembly and reassembly. If touch functionality does not return after replacement, inspect connectors and cable routing for proper seating and check system software for required drivers or firmware updates.