Punta KWB 706360 6 cm

The KWB 706360 6 cm drill bit is designed for drilling into chipboard, MDF and softwood. With a 6 cm diameter it is suitable for creating clean, reasonably sized holes for dowels, fittings and other joinery elements. Constructed to provide precision and consistent results, this single drill bit is intended for both DIY and professional tasks where controlled penetration and smooth hole edges are required.

Advantages

This drill bit offers a defined diameter of 6 cm for repeatable hole sizes and is constructed to deliver clean cuts in chipboard, MDF and softwood. Its single-piece design simplifies handling and replacement, while the geometry supports accurate guidance and reduced tear-out on the workpiece. The bit is compatible with standard drilling tools used in woodworking applications.

Suitable for

Key specifications

How to use

Select a drill or drilling device compatible with the drill bit shank and secure the bit according to the tool manufacturer’s instructions. Mark the drilling position on the workpiece, clamp the material to prevent movement, and start drilling at low speed to establish the hole before increasing speed as needed. Apply steady, even pressure and withdraw the bit periodically if required to clear chips. After drilling, inspect hole edges and remove any remaining debris before assembly.

Recommendations

Use appropriate protective equipment such as safety glasses and hearing protection. For best results in chipboard and MDF, support the underside of the workpiece or use sacrificial backing to reduce splintering. Ensure the drill is aligned perpendicular to the work surface for accurate, clean holes.