Punta per trapano a percussione Bosch B 2608833802 — punta per trapano a percussione, diametro 10 mm, 1 pezzo

Bosch hammer drill bit B 2608833802 is a single-piece SDS plus percussion drill designed for use with rotary hammers. With a 10 mm diameter, this 1 pc drill bit is intended for efficient drilling in masonry and concrete, creating precise holes for anchors, dowels and pipe passages. The tool combines a turn-angle head and a 4-flute geometry to enhance dust extraction and drilling speed while providing stable guidance and long life.

Advantages

The turn-angle head and 4-flute design enable fast removal of debris, increasing drilling progress and reducing wear. A centring tip ensures accurate guidance from the start for exact hole diameters and consistent results. Manufactured to tight tolerances under the PGM quality standard, the bit provides secure hold of fixings and predictable performance in professional and DIY applications. The single-piece construction offers durability and reliability during repeated percussion drilling.

Suitable for

• Percussion drilling in masonry and concrete
• Creating holes for anchors and wall plugs
• Drilling passages for small-diameter pipes and conduits
• Use with SDS plus rotary hammer tools on construction and renovation sites

Key specifications

• Shank system: SDS plus compatible
• Diameter: 10 mm
• Length type: standard single-piece bit (compact for general drilling)
• Tip design: centring tip for precise start and accurate hole diameter
• Flute design: 4-flute geometry for improved dust removal and drilling speed
• Head type: turn-angle head for efficient cutting in reinforced concrete
• Suitable material: masonry, concrete, including reinforced concrete

How to use

Insert the SDS plus shank into the rotary hammer’s chuck until it clicks and test the locking before starting. Select hammer-percussion mode and apply steady axial pressure while allowing the drill to do the cutting; avoid excessive lateral force. Start at low rpm to allow the centring tip to position the bit accurately, then maintain a consistent drilling rhythm. Periodically withdraw the bit to clear accumulated dust and extend bit life, especially when drilling deep holes for anchors or conduits.

Recommendations

Use appropriate personal protective equipment including safety glasses, hearing protection and dust mask when drilling. Match drill speed and hammer impact setting to wall material and hole depth. For reinforced concrete, apply moderate, steady pressure and allow the 4-flute geometry to remove debris; for long or deep holes, clear the hole regularly to prevent packing and overheating.