Barra luminosa LED Lamptron FlexLight Multi RGB con telecomando a infrarossi, 5 m

Lamptron FlexLight Multi RGB is a 5 m flexible LED light strip with infrared remote control for adjustable ambient and accent lighting. The strip offers multi-color RGB output, variable brightness and selectable lighting modes to create consistent backlighting in PC cases, shelving, cabinets, gaming setups and general room mood lighting. Adhesive backing and a thin, bendable design allow for installation on flat or curved surfaces and easy routing inside furniture or computer enclosures.

Advantages

The infrared remote enables quick selection of colors, modes and brightness without additional software or wiring. A full 5 m length provides continuous illumination for large surfaces or multiple mounting runs. The flexible PCB and adhesive tape ensure straightforward installation, while RGB color mixing allows smooth transitions and a wide palette of hues. The strip is low-profile and energy-efficient, suitable for long-term use as accent or ambient lighting.

Suitable for

• Interior PC case lighting and modding
• Under-shelf and cabinet accent lighting
• Backlighting for monitors, TVs and displays
• Ambient mood lighting in living rooms, bedrooms or gaming areas
• Decorative lighting for furniture or shelving units

Key specifications

• Length: 5 meters of continuous LED strip
• Light type: RGB multi-color LEDs with color mixing
• Control method: infrared remote for color, mode and brightness selection
• Mounting: self-adhesive backing for attachment to flat or slightly curved surfaces
• Flexibility: bendable strip suitable for routing around corners and into tight spaces
• Power characteristics: low-voltage LED strip designed for energy-efficient operation

How to use

Prepare the mounting surface by cleaning and drying it to ensure good adhesion. Measure and plan the routing path, cut the strip only at marked cut points if a shorter length is required, and press the adhesive backing firmly onto the surface. Connect the strip to a compatible low-voltage power source and aim the infrared remote at the receiver to change colors, select lighting modes or adjust brightness. Avoid placing the strip near heat sources or in areas where it may be exposed to water unless additional protection is applied.

Recommendations

For best results, test the strip and remote before final mounting, allow the adhesive to bond for several hours before applying stress, and route cables to minimize visible wiring. Use compatible power adapters rated for LED strips and avoid continuous operation at maximum brightness to extend LED lifespan.