Modulo SFP in fibra ottica CBO SFP-1FEMLC-T-BO 100 Mbit/s monomodale LC fino a 2000 m

The BlueOptics Fiber optic SFP module CBO SFP-1FEMLC-T-BO delivers 100 Mbit/s data transmission over single-mode fiber using an LC connector and supports link distances up to 2000 m. It is a compact SFP transceiver intended for use in compatible SFP slots on switches, routers and industrial network equipment. The module supports hot-swap installation and provides a stable physical layer interface for Ethernet uplinks and point-to-point fiber links.

Advantages

This SFP module offers a standardized small-form-factor design that simplifies integration into existing network hardware. With single-mode fiber support and an LC connector it enables long-reach connections up to 2000 m while maintaining a 100 Mbit/s data rate. The transceiver’s hot-pluggable capability allows maintenance and upgrades without powering down the host device, and the compact module minimizes rack space usage and maintains compatibility with a wide range of switches and routers that accept SFP modules.

Suitable for

Key specifications

How to use

Insert the SFP module into a compatible SFP slot on your switch, router or industrial device until it latches. Connect single-mode LC fiber patch cables to the module’s LC connectors, observing transmit and receive orientation. Power on the host device if it is not already running; the module supports hot-swap so it can also be inserted or removed while the device is powered in accordance with the host’s guidelines. Configure the network interface in the device management interface or operating system to enable the 100 Mbit/s Ethernet link and verify link status and diagnostics through the host switch or router.

Recommendations

Use single-mode LC patch cables with appropriate fiber management to maintain optimal signal quality and minimize bend radius violations. Verify compatibility with the host device’s SFP slot and consult the equipment vendor’s documentation for any firmware or compatibility notes. Perform link testing after installation to confirm expected throughput and reach.