BlueOptics SFP28-AOC-15M-RW-BO cavo in fibra ottica InfiniBand 15 m SFP28 maschio

The BlueOptics SFP28-AOC-15M-RW-BO is a 15 metre active optical cable (AOC) with SFP28 male connectors designed for InfiniBand and multi-mode fibre connections. It supports 25G data rates using a 25GBASE-SR4 compliant interface and integrates a transmitter and receiver in each connector for optical signal conversion over multi-mode fibre. The cable is intended for short-reach, high-bandwidth links between switches, routers, servers and storage systems in data centre and high-performance computing environments.

Advantages

This AOC provides low-latency, high-throughput connectivity for 25G applications while eliminating the need for separate transceivers and patch cords. SFP28 form-factor compatibility ensures plug-and-play installation in ports that accept SFP28 modules, and the integrated transceiver electronics reduce cable weight and power consumption compared with equivalent copper direct-attach solutions. Multi-mode fibre construction is optimised for short-reach links up to the specified 15 metre length.

Suitable for

• High-density server and switch interconnects in data centres
• High-performance computing clusters and InfiniBand fabrics
• Storage area network (SAN) links and aggregation ports
• Short-reach 25G Ethernet and Fibre Channel over Ethernet connections

Key specifications

• Connector type: SFP28 male to SFP28 male
• Cable type: Active Optical Cable (AOC), multi-mode fibre
• Maximum supported data rate: 25 Gbit/s per link
• Standard compliance: 25GBASE-SR4 compatible
• Length: 15 metres
• Typical use: short-reach, high-bandwidth interconnects

How to use

Insert the SFP28 connectors into compatible SFP28 ports on networking equipment such as switches, routers, servers or storage systems. Ensure both ends are fully seated and that connected devices support 25G operation and the SFP28 form factor. No separate fibre patch panels or transceivers are required; the integrated transceivers handle optical conversion. After connection, verify link status on each device and configure network interfaces as needed for the chosen protocol (Ethernet, Fibre Channel over Ethernet or InfiniBand).

Recommendations

Use the cable within equipment vendor compatibility lists and supported port configurations. Avoid tight bends and excessive stress on the fibre cable, maintain minimum bend radius as specified by the manufacturer, and keep the connectors clean and protected when not in use. For critical environments, validate performance with a test sample and confirm that connected hardware firmware and drivers support SFP28 AOC modules at 25G speeds.