Cavo CableMod 12VHPWR su 3× PCIe ModMesh 60 cm — CableMod C-Series Pro (rosso scuro)

The CableMod 12VHPWR to 3× PCIe ModMesh cable 60 cm — CableMod C-Series Pro (Dark Red) converts a single 12VHPWR power output into three separate 8-pin PCIe power connectors across a 60 cm length. Intended for builds that require distributing GPU power or powering multiple graphics cards/adapters from one 12VHPWR source, this cable uses CableMod's ModMesh sleeving in a dark red finish to match custom PC color schemes and improve cable routing in compact or multi-GPU setups.

Advantages

This cable offers a compact and flexible solution for splitting a single 12VHPWR connector into three PCIe power outputs without the need for additional adapters at the PSU. The ModMesh sleeving provides abrasion resistance and a consistent aesthetic, while the 60 cm length balances reach and tidy cable management. The design supports clean routing in small form-factor or multi-GPU configurations where multiple PCIe power feeds are needed.

Suitable for

• Custom PC builds requiring split GPU power distribution
• Small form-factor systems where cable routing space is limited
• Setups using adapters or risers that need multiple PCIe power connectors
• Systems where consistent cable aesthetics and sleeving are desired

Key specifications

• Cable type: 12VHPWR to 3× PCIe power cable
• Length: 60 cm (approximate usable length for routing)
• Sleeving: ModMesh fabric sleeving
• Color: dark red finish
• Connector configuration: one 12VHPWR input to three 8-pin PCIe outputs
• Intended use: internal PC power distribution for graphics cards and adapters

How to use

Power off the system and disconnect the power supply before installation. Connect the 12VHPWR plug to the corresponding 12VHPWR output on your power supply or adapter, then route the sleeved cable to the target graphics cards or PCIe devices and attach each 8-pin PCIe connector to the device’s power input. Ensure connectors are fully seated and secure cable routing to avoid strain on connectors or interference with fans and components. After installation, verify connections visually and power on the system to confirm stable operation.

Recommendations

Use this cable only with compatible 12VHPWR outputs and PCIe devices. Check the power requirements of connected GPUs and adapters to avoid overloading a single 12VHPWR source. Maintain proper airflow and avoid tight bends at connector ends; secure the cable with ties or straps as needed to prevent movement during operation.