Cavo di alimentazione InLine, spina Euro / spina Euro8 angolare, nero, 2 m

The InLine power cable CEE7/16 to C7 angled in black, 2 m, provides a standard mains connection for devices with an IEC C7 (Euro 8 / figure-8) inlet. The cable features a Euro mains plug (CEE7/16) on one end and a right-angle C7 coupler on the other, designed to save space behind equipment. Constructed for indoor use with a conductor cross-section of 0.75 mm², the cable supports rated voltage up to 250 V AC and rated current up to 2.5 A (maximum power 625 W). The moulded plugs and compliance with European plug standards make the cable suitable for a wide range of small appliances and AV devices that require a secure, standard power connection.

Advantages

The angled C7 connector minimises strain and allows installation in tight spaces directly behind furniture or equipment. A 0.75 mm² conductor cross-section provides a stable power feed within the specified ratings, while the moulded plugs ensure consistent contact and mechanical durability. The use of the standard Euro mains plug enables compatibility with European wall sockets without adapters. The cable is produced for dry indoor environments and is available in a 2 m length for flexible placement of devices.

Suitable for

• Small household electronics such as radios, cassette players and chargers
• AV equipment including CD, DVD and Blu‑ray players and flat screens
• Game consoles and slim power supplies (e.g., PS2/PS3 Slim/PS4, XBOX One S)
• Laptop power adapters and external power supplies with IEC C7 inlet

Key specifications

• Plug type: Euro mains plug (CEE7/16), 2‑pin
• Device connector: IEC C7 (Figure‑8), right‑angle
• Cable length: 2 m
• Conductor cross‑section: 0.75 mm²
• Rated voltage: 250 V AC
• Rated current: 2.5 A
• Maximum power: 625 W
• Colour: Black
• Intended application area: Indoor use

How to use

Connect the Euro mains plug (CEE7/16) to an appropriate European wall socket and insert the angled IEC C7 coupler into the device’s figure‑8 inlet. Ensure the device and cable ratings do not exceed 250 V, 2.5 A and 625 W. Position the right‑angle connector so it sits flush with the device housing to reduce strain on the cable. Do not use the cable in wet or outdoor environments and avoid routing it across sharp edges or near heat sources.

Recommendations

Use the cable only with devices that accept an IEC C7 connector and within the specified electrical ratings. Inspect plugs and cable insulation for damage before each use, avoid excessive bending at the connector ends, and replace the cable if any wear or damage is detected. For permanent installations or higher power devices, select a cable and connector rated for the required current and power.