Cavo di rete Deltaco TP-610S RJ-45 Cat6 10 m nero

The Deltaco TP-610S is a UTP Cat6 networking cable designed for wired Ethernet connections. Measuring 10 m in length and finished in black, the cable uses RJ-45 connectors with gold plating to support reliable signal transfer. It is built for 10/100/1000Base-T(X) networks and supports a data transfer rate specified at 1024 Mbit/s, making it suitable for typical home and office network setups that require Cat6 performance over a moderate distance.

Advantages

This Cat6 cable offers consistent electrical performance for Gigabit Ethernet thanks to Category 6 construction and UTP design. The gold-plated RJ-45 connectors provide improved contact reliability and reduced oxidation risk compared with unplated contacts. The 10 m length allows flexible placement of devices without using multiple shorter cables or extenders, and the black jacket provides a low-profile appearance that blends into most installations.

Suitable for

• Connecting desktop computers, laptops and network switches in home or small office environments
• Linking routers to modems or wall Ethernet outlets within a 10 m range
• Establishing wired connections for media players, smart TVs or network printers

Key specifications

• Cable category: Cat6 (UTP)
• Length: 10 m
• Connector type: RJ-45 to RJ-45
• Connector plating: Gold-plated contacts
• Supported cabling technology: 10/100/1000Base-T(X)
• Colour: Black
• Declared data transfer rate: 1024 Mbit/s

How to use

Plug one RJ-45 connector into the Ethernet port of your modem, router, switch, or network device and the other connector into the corresponding device or wall outlet. Ensure connectors click into place to confirm a secure physical connection. Route the cable to avoid sharp bends and pinch points, and keep it clear of sources of electrical interference where possible. For best network performance, use straight-through wiring endpoints and verify link speed and duplex settings on connected devices if needed.

Recommendations

For stable Gigabit connections, avoid excessive bending and kinking of the cable and keep length within the specified 10 m to minimize signal loss. When deploying near power cables or large electrical equipment, maintain separation to reduce electromagnetic interference. Inspect connector ends before use and replace the cable if the jacket or connectors are physically damaged.