Cavo DMX 3 m EUROLITE XLR 3 poli per controllo luci

EUROLITE DMX cable 3 m with standard 3-pin XLR connectors is designed to transmit DMX512 lighting control signals between consoles and fixtures over short runs. The cable provides a straightforward wired connection for stage and event setups, offering reliable signal transfer for basic lighting chains. Its 3-meter length balances reach and neat cable management for compact installations and rehearsal spaces.

Advantages

The cable uses industry-standard 3-pin XLR connectors compatible with a wide range of lighting consoles, dimmers, moving heads and LED fixtures. Its construction prioritizes consistent electrical contact and low signal loss across short distances, reducing the chance of intermittent control failures in simple setups. The flexible jacket and secure connector housings support easy routing and handling during installation and breakdown.

Suitable for

Key specifications

How to use

Connect the 3-pin XLR male end to the DMX output of the control console and the 3-pin XLR female end to the DMX input of the first fixture, dimmer or splitter. For longer chains, continue linking fixtures using additional DMX cables and maintain correct DMX daisy-chain topology. Ensure connectors are fully seated and secured to prevent intermittent contact. When the run is the last fixture in the line, use proper DMX termination at the final DMX input to minimise signal reflections.

Recommendations

Use this 3 m DMX cable for short to medium runs in stage, club and rehearsal environments. Avoid using standard DMX wiring for permanent outdoor installations without additional weatherproofing. For longer runs or complex setups consider cables with higher-grade shielding or 5-pin DMX variants where required by your equipment.