Cavo DMX EUROLITE EC-1 IP65 3 poli 20 m per controllo luci

EUROLITE EC-1 IP65 DMX cable is a 3-pin, 20 m cable engineered for DMX lighting control where splash and dust resistance are required. The cable supports standard 3-pin DMX connections used to link fixtures, dimmers and controllers across medium distances. Its IP65-rated jacket provides protection against water jets and dust ingress, making it suitable for temporary outdoor installations as well as demanding indoor environments where moisture or dirt may be present.

Advantages

The cable combines robust mechanical construction with shielding and conductor design that reduce signal loss and interference along the 20 m run. The IP65 rating ensures resistance to splashes and particulate contamination, improving reliability in outdoor events and festival setups. Durable outer insulation and strain relief at the connectors extend service life under repeated handling and movement, while maintaining compatibility with common 3-pin DMX fixtures and controllers.

Suitable for

Key specifications

How to use

Connect one end of the DMX cable to the DMX output of the controller or previous fixture and the other end to the DMX input of the next fixture, observing correct pin alignment for 3-pin DMX connections. For long runs or multiple fixtures, maintain proper DMX termination at the end of the chain to prevent signal reflections. Ensure connectors are fully engaged and, when used outdoors or in damp conditions, check that seals and joints are dry and properly seated before powering equipment.

Recommendations

Route the cable to avoid sharp bends and pinch points, and secure it where movement could cause wear. For repeated outdoor use, rinse off salt and debris after use and inspect the jacket and connectors for damage. Use appropriate DMX terminators and avoid combining with high-voltage power lines in the same conduit to minimize interference.