Chiodi in coil BeA BDC 2,5x50 mm grezzi lisci, confezione da 9000

Coil nails BeA BDC 2.5x50 mm blank smooth, pack of 9000 are smooth, uncoated nails supplied in a large coil for use with compatible pneumatic coil nailers. The 2.5 mm shank thickness and 50 mm length deliver consistent penetration and holding power in soft and semi-hard timber. Packed as 9,000 pieces per coil, these nails are intended for high-volume nailing tasks where continuous feed and reduced downtime are important.

Advantages

These blank smooth nails provide predictable driving behavior and minimal surface marking due to their uncoated finish. The coil format allows long, uninterrupted work cycles and reduces magazine reloads on compatible coil nailers. The combination of shank diameter and length gives a balance between shear strength and withdrawal resistance for typical carpentry applications.

Suitable for

Key specifications

How to use

Load the coil into a compatible pneumatic coil nailer following the tool manufacturer’s instructions. Ensure the nailer is set to the correct pressure range for 2.5 x 50 mm nails and adjust depth-of-drive as needed to attain flush or slightly countersunk heads, depending on the application. Position the nailer perpendicular to the work surface and drive nails at appropriate spacing for the timber type and load requirements. Observe safe operating procedures, including the use of eye and hearing protection and ensuring the workpiece is properly supported.

Recommendations

For best performance, use these nails in dry, clean timber and verify nail length versus material thickness to avoid through-penetration. When fastening harder or treated woods, confirm compatibility with your nailer and consider pre-drilling or selecting a nail with a different finish or shank type if withdrawal resistance or corrosion protection is required.