Connettore per cavo RJ-45 ShiverPeaks BS72051R-10

The ShiverPeaks BS72051R-10 is a pack of 10 male RJ-45 wire connectors in white designed for terminating network cables and creating reliable Ethernet connections. Each connector accepts standard 8P8C twisted-pair cable and provides a compact, insulated housing to protect contacts and maintain stable signal transmission. These RJ-45 connectors are suitable for use in home networks, office installations, patch panels and custom cable assemblies where a secure mechanical and electrical connection is required.

Advantages

These RJ-45 wire connectors offer consistent contact alignment and a clear, insulated body that makes wire insertion and inspection straightforward. The connectors are produced to meet typical mechanical and electrical requirements for copper twisted-pair cabling, providing low insertion loss and stable contact pressure over repeated mating cycles. Their standard form factor and white finish allow easy identification and integration into a variety of network setups without altering cable management practices.

Suitable for

• Terminating Cat5e and Cat6 twisted-pair Ethernet cables
• DIY network cable assembly and repairs
• Creating patch cables for routers, switches and patch panels
• Small office and home networking installations

Key specifications

• Connector type: male 8P8C (RJ-45) for twisted-pair copper cable
• Pack quantity: 10 pieces
• Housing color: white
• Insulation: molded clear/white plastic body for wire visibility and protection
• Contact finish and material: conductive metal contacts designed for reliable copper conductor contact
• Compatibility: standard Ethernet cabling (Cat5e/Cat6) and tools for crimping RJ-45 connectors

How to use

Strip the outer jacket of the network cable to expose the twisted pairs, untwist and align the conductors according to the desired wiring standard (T568A or T568B). Insert the wires fully into the connector until the cable sheath seats against the connector body. Use a compatible RJ-45 crimping tool to crimp the connector, ensuring the contacts pierce the conductor insulation and the strain relief engages the cable jacket. Verify continuity with a cable tester before deploying the cable in the network.

Recommendations

For consistent results, use the connectors with properly prepared Cat5e or Cat6 cable and a quality crimping tool. Avoid excessive cable jacket stripping and ensure pairs remain twisted as close to the termination point as possible to preserve signal integrity. Test each terminated cable for continuity and pair mapping to confirm correct installation.