Creality ENDER3 V2 NEO motore passo-passo asse Y 42-34 accessorio Creality 3D

When your Creality Ender-3 V2 Neo starts missing steps on the Y-axis or produces layer shifts, the original 42-34 stepper motor is often the culprit. This direct replacement restores precise bed movement, ensuring your prints come out clean and dimensionally accurate. Ideal for makers, hobbyists, and print farms that rely on consistent output from their Ender-3 V2 Neo printers.

Key specifications

• Motor type: NEMA 17 bipolar stepper motor (42mm x 42mm frame)
• Body length: 34 mm
• Step angle: 1.8° (200 steps per revolution)
• Rated voltage: 2.55 V DC
• Rated current: 1.5 A per phase
• Holding torque: approximately 0.35 N·m
• Phase resistance: approximately 1.7 Ω
• Phase inductance: approximately 2.5 mH
• Shaft diameter: 5 mm
• Number of leads: 4
• Connector: JST-XH 4-pin
• Insulation class: Class B
• Operating temperature: -10°C to 50°C

Why choose it

This motor is a genuine Creality spare part, guaranteeing perfect compatibility with the Ender-3 V2 Neo. It delivers the exact torque and speed characteristics required for smooth Y-axis motion, eliminating guesswork and tuning. Swapping it in takes minutes and restores your printer to factory performance.

Ideal use cases

• Replacing a worn or damaged Y-axis motor on an Ender-3 V2 Neo
• Keeping a spare motor on hand for quick repairs in a busy workshop
• Upgrading a printer that has been fitted with a non-original motor of incorrect specification
• Maintaining a fleet of Ender-3 V2 Neo printers in an educational or professional setting

Good to know

The motor comes with the standard 4-pin JST-XH connector used by Creality, so no soldering or crimping is needed. Always power off and unplug your printer before installation. After replacement, check the Y-axis belt tension and ensure the motor cable is routed away from moving parts.