Dimmer pack LED DMX RDM EUROLITE EDX-4 4 canali 10 A

EUROLITE EDX-4 DMX RDM 4-channel 10 A is a compact LED dimmer pack designed for centralized control of LED fixtures and low-voltage loads. The unit provides four separately addressable channels with DMX input and supports RDM for remote configuration and status monitoring. Each channel is rated for a maximum continuous current of 10 A, making the device suitable for small- to medium-scale stage, event and architectural lighting applications where individual channel control and space-saving installation are required.

Advantages

The EUROLITE EDX-4 integrates DMX control with RDM compatibility, allowing remote parameter adjustment and simplified addressing without direct physical access to the unit. Four independent channels with 10 A current capacity per channel enable flexible distribution of load among fixtures, and the compact housing facilitates installation in racks, on truss, or in confined technical spaces. The device is engineered to deliver consistent dimming performance for LED and other low-voltage lighting loads while maintaining separate channel control.

Suitable for

Key specifications

How to use

Install the EUROLITE EDX-4 in a suitable enclosure, rack space or fixed mounting location with access to the DMX signal source. Connect each channel output to the corresponding LED fixture or low-voltage load, observing correct polarity and wiring practices. Address the unit and individual channels via a DMX console or use RDM to remotely assign addresses and configure parameters. Ensure that the total current on each channel does not exceed the 10 A rating and verify wiring and load types before powering the system.

Recommendations

For reliable operation, use compatible LED fixtures and cabling rated for the intended currents. Allow ventilation around the dimmer pack and avoid overloading any single channel. When using RDM, confirm that the DMX network and connected devices support the protocol to enable remote configuration and status feedback.