Extension Offset (confezione da 2) BitsPower BPTA-PAM-GB — nero, connettori angolari per raffreddamento a liquido PC

BitsPower Offset extension (2-pack) BPTA-PAM-GB are black angled extensions for PC watercooling systems that create an offset between G1/4 threaded fittings and components. Designed to help route tubing around obstacles and achieve cleaner alignments in compact or complex builds, this two-piece set provides a simple mechanical solution for adjusting tube position without changing tubing length or reworking other fittings.

Advantages

These angled extensions allow precise offset alignment while preserving standard G1/4 thread compatibility. The black finish integrates visually with dark-themed builds, and the compact angled profile reduces stress on tubing by improving connector orientation. Supplied as a 2-pack, the set offers an economical way to adjust multiple connections in a loop and maintain a tidy layout.

Suitable for

• Custom PC liquid-cooling loops where tubing must clear tight spaces or obstacles
• Rear or obstructed ports that require angled connection to radiator, pump, or reservoir
• Systems using standard G1/4 threaded fittings seeking improved tube routing

Key specifications

• Color: black
• Quantity: 2 pieces per pack
• Thread standard: G1/4 compatible
• Type: angled offset extension for watercooling fittings
• Material: metal construction (surface coated/finished)

How to use

Install the extension by screwing it into an existing G1/4 threaded fitting or component port until hand-tight, then secure with an appropriate wrench if required to ensure a leak-free connection. Attach the mating G1/4 fitting or tubing connector to the free end of the offset extension. Check alignment and orientation before final tightening to achieve the desired tube routing and avoid over-torquing. After installation, pressure-test the loop following standard watercooling safety procedures.

Recommendations

Use compatible G1/4 fittings and standard sealing methods (PTFE tape or appropriate gaskets) when installing the offset extensions. Inspect threaded seals and perform a controlled leak test before powering the system. For best routing results, combine these extensions with appropriately sized tubing and angled compression fittings as needed.