Cavo DisplayPort Alcasa 4810-010G 1m nero

The Alcasa DisplayPort to DisplayPort cable by Good Connections is a 1 m black cable designed to connect devices with DisplayPort interfaces. It provides a direct link for transmitting digital video and audio signals between compatible monitors, graphics cards, docking stations and other DisplayPort-equipped devices. The cable's standard length and black finish make it suitable for typical desktop and office installations where a discrete, reliable connection is required.

Advantages

The cable delivers stable digital transmission of video and audio over a 1 m length with secure connectors that reduce the risk of signal loss. Its DisplayPort-to-DisplayPort design supports straightforward plug-and-play setup without additional adapters. The black exterior helps the cable blend with most PC and monitor setups while the molded connectors offer consistent mating and durability for repeated use.

Suitable for

• Connecting a desktop PC or laptop graphics output to a DisplayPort monitor
• Linking a docking station or port replicator to an external display
• Connecting a graphics card to a single-monitor workstation
• Short runs behind desks or on crowded workstations where a 1 m cable is sufficient

Key specifications

• Cable length: 1 m
• Connector type: DisplayPort to DisplayPort
• Colour: Black
• Cable use: Digital video and audio signal transmission between DisplayPort devices

How to use

Insert one DisplayPort connector into the DisplayPort output of your source device (for example a PC graphics card or docking station) and the other connector into the DisplayPort input of your monitor or display. Make sure both connectors are fully seated and, if present, the connector latch engages to secure the connection. Configure the display settings on your computer if needed to select resolution, refresh rate and audio routing.

Recommendations

For reliable performance, avoid sharp bends and excessive tension in the cable and route it away from high-voltage power lines or sources of electromagnetic interference. Use the 1 m length for near-field connections; for longer runs select a cable with appropriate length and specifications to maintain signal quality.