Gruppo coperchio Type 2 Charge Amps Dawn – coperchio di ricambio per caricabatterie EV Dawn

The Charge Amps Dawn Type 2 Lid Assembly is a replacement cover engineered for the Charge Amps Dawn electric vehicle charger with a Type 2 inlet. It functions as the external faceplate that defines the opening and mounting interface for the vehicle connector, restoring the charger’s enclosure integrity after wear, damage or during refurbishment. The part is intended for service and repair tasks where a precise fit and correct alignment to the Type 2 inlet are required.

Advantages

This lid assembly is manufactured to match the original Dawn charger profile, providing consistent alignment with the Type 2 inlet and surrounding enclosure. Using a correct-fit replacement helps maintain weather-resistant sealing and preserves the mechanical mounting points for the connector. The component simplifies repair workflows by eliminating the need for custom modifications and supports continued use of the existing charging electronics and mounting hardware.

Suitable for

Key specifications

How to use

Before installation, disconnect power to the charging unit and follow all safety procedures for working on electric vehicle chargers. Remove the existing lid assembly by loosening mounting fasteners and carefully detaching any sealing gaskets. Align the replacement lid with the Type 2 inlet cutout and mounting points, ensure gasket seating is correct to maintain ingress protection, then secure the fasteners to the manufacturer’s recommended torque. Verify connector alignment and close/open operation before restoring power.

Recommendations

Use this replacement lid as part of a proper service procedure; inspect surrounding enclosure seals and mounting hardware for wear and replace as needed to preserve weather resistance and safe operation.