HPE MEM 32GB 2Gx8 DDR5 4800 MHz SPS-DIMM

The HPE DDR5 32GB 4800MHz memory module provides 32 GB of DDR5 system memory operating at a clock speed of 4800 MHz in a 288-pin DIMM form factor. Designed for HP Enterprise platforms and compatible servers or workstations that accept 288-pin DDR5 DIMMs, this module supports higher bandwidth and improved performance for multi-threaded workloads and memory-intensive tasks. It is intended as an upgrade to increase available system memory, reduce swapping to secondary storage, and improve responsiveness for virtualization, large databases, and data analysis applications.

Advantages

This 32 GB DDR5 module increases memory capacity and bandwidth compared with earlier generations, enabling better multitasking and reduced latency under load. The 4800 MHz clock speed delivers faster data transfer rates for memory-bound processes, while the 288-pin DIMM form factor ensures physical compatibility with standard DDR5-capable server and workstation motherboards. The module is suitable for scaling system memory in multi-socket or single-socket configurations to meet the requirements of modern enterprise workloads.

Suitable for

• Server and workstation memory upgrades
• Virtualization hosts and hypervisor environments
• In-memory databases and data analytics
• High-performance computing and scientific applications
• Multitasking environments with large working sets

Key specifications

• Capacity: 32 GB
• Memory type: DDR5
• Clock speed: 4800 MHz
• Form factor: 288-pin DIMM
• Module use: Registered or unbuffered compatibility depends on system specification (verify motherboard support)

How to use

Power down the system and disconnect it from the power source before installing the DIMM. Open the server or workstation chassis according to the manufacturer’s instructions and locate the DDR5-compatible DIMM slots. Align the module with the slot using the notch on the 288-pin edge connector, insert it evenly and press until the retention clips engage. After installation, reconnect power and start the system; verify that the BIOS or system firmware recognizes the new 32 GB module and that memory settings match the required configuration for stable operation.

Recommendations

Verify motherboard and BIOS support for DDR5 288-pin DIMM modules and check whether registered (RDIMM), load-reduced (LRDIMM) or unbuffered (UDIMM) memory is required by your system. Install DIMMs in matched pairs or according to the board’s recommended population order to ensure optimal performance and channel interleaving. Apply standard ESD precautions during handling and consult system documentation for maximum supported memory per channel and per socket.