Modulo ricetrasmettitore di rete ALLNET ALL4765

The ALLNET ALL4765 is a compact mini-GBIC network transceiver module designed for 1 Gbit/s fiber connections. With an SFP fiber optic connector and support for data rates up to 1000 Mbit/s, the module enables reliable uplinks and fiber links in switches, routers and media converters. Its small form factor and 20 g weight make it suitable for installations where space and weight are limited while maintaining standard SFP compatibility with many common networking devices.

Advantages

The module offers a standardized mini-GBIC interface that simplifies hot-swappable installation and replacement. Its support for 1000 Mbit/s ensures gigabit-capable fiber links for backbone or edge connections. The grey, compact housing reduces space requirements in patch panels and chassis while providing physical durability for typical rack and cabinet environments. Broad compatibility with several vendor devices facilitates integration into mixed-brand networks.

Suitable for

• Establishing single-mode or multimode fiber links in enterprise and SMB networks
• Upgrading switch or router ports to gigabit fiber connectivity
• Replacing or expanding SFP ports in media converters and transceivers
• Deployments where compact, hot-swappable modules are required

Key specifications

• Interface type: mini-GBIC (SFP form factor)
• Maximum data transfer rate: 1000 Mbit/s (1 Gbit/s)
• Connector type: SFP fiber optic connector
• Typical use: fiber uplinks and gigabit links
• Colour: Grey
• Weight: approximately 0.02 kg

How to use

Ensure the host device supports SFP mini-GBIC modules before installation. Power down the target port or follow the device's hot-swap guidelines, then insert the ALLNET ALL4765 into an available SFP slot until it seats firmly. Connect the appropriate fiber optic cable to the module's SFP connector, observing correct transmit/receive orientation. Configure the host device's port settings if necessary to enable 1 Gbit/s operation and verify link status through the device management interface.

Recommendations

Use fiber cables and transceivers that match the link distance and fiber type requirements. Avoid inserting or removing the module with active fiber cables connected to prevent connector damage. Check vendor compatibility lists for firmware or hardware restrictions when integrating the module into mixed-brand environments.