Patriot Viper Gaming XTREME 5 DDR5-7600 RAM, CL 36, Intel XMP 3.0 - 48GB Dual-Kit, nero

The Patriot Memory Viper Xtreme 5 48 GB DDR5 7600 MHz (2 x 24 GB) SO-DIMM is a high-performance laptop memory kit that uses DDR5 technology and a 262-pin form factor. Rated for 7600 MHz operation and supplied with three selectable XMP 3.0 profiles, this module is prepared for demanding multitasking, content creation and gaming on supported laptop platforms. It is hand-tested on current Intel DDR5 platforms, built from quality components, and covered by a limited lifetime warranty. Note that unsupported or older platforms may require manual tuning or run the module at reduced speeds.

Advantages

The Viper Xtreme 5 kit offers high clock speeds and a large 48 GB capacity to improve responsiveness in memory-intensive applications. DDR5 architecture delivers higher bandwidth and improved efficiency compared with previous generations, while the SO-DIMM 262-pin form factor ensures compatibility with many modern laptops. Three XMP 3.0 profiles provide flexible overclocking options and simplified configuration on compatible systems. Low operating voltage helps reduce power draw in portable systems without sacrificing performance.

Suitable for

• Multitasking with many simultaneous applications and browser tabs
• Video editing, 3D rendering and content creation workflows
• High-performance gaming on DDR5-equipped laptops
• Software development, virtual machines and heavy data processing
• Upgrading compatible laptops to increase total memory capacity

Key specifications

• Total capacity: 48 GB (2 x 24 GB)
• Memory type: DDR5
• Speed: 7600 MHz
• Form factor: 262-pin SO-DIMM
• Operating voltage: 1.1 V
• Weight: approximately 0.049 kg (kit)
• Three selectable XMP 3.0 overclock profiles

How to use

Power off the laptop, disconnect any power sources and remove the battery if applicable before installing the memory. Open the memory compartment following the laptop manufacturer's instructions, align each SO-DIMM module with the slot notch, insert at an angle and press down until the retaining clips engage. Reassemble the laptop, reconnect power and start the system. Enter the firmware/BIOS/UEFI settings to verify memory recognition and to select an appropriate XMP 3.0 profile if supported by the platform. If the system is unstable after enabling a profile, revert to the default setting or manually adjust timings and voltages as recommended by the laptop vendor.

Recommendations

Ensure your laptop supports DDR5 SO-DIMM modules and the target speed; consult the laptop documentation or manufacturer support for compatibility details. For best results, install memory modules in matching pairs and update firmware/BIOS to the latest version before enabling XMP profiles. If any instability occurs, try lowering speed or using default settings to achieve a stable configuration.