Striscia LED, Singularity Computers Spectrum 2.0 ARGB 90° daisy-chain 500 mm

Singularity Computers Spectrum 2.0 ARGB 90-degree daisy-chain 500 mm LED strip is a 500 mm addressable RGB lighting accessory designed for PC case illumination and custom lighting configurations. The strip features an integrated right-angle connector and daisy-chain capability that simplifies routing and allows multiple strips to be linked while maintaining signal synchronization with compatible ARGB controllers or motherboard headers.

Advantages

The Spectrum 2.0 ARGB strip provides addressable RGB control along its length, enabling per-LED effects and smooth color transitions when paired with compatible controllers. Its 90-degree connector reduces strain on cables and helps route lighting cleanly in tight case builds. Daisy-chain capability lets you extend a lighting run without additional wiring to the controller, maintaining synchronized effects across linked strips.

Suitable for

• Illuminating PC cases with synchronized ARGB lighting
• Custom lighting layouts in small or compact builds where right-angle connections simplify routing
• Linking multiple LED strips to create continuous lighting runs without extra controller ports

When it may not be suitable

This LED strip requires an addressable RGB (ARGB) compatible controller or motherboard header to provide power and signal; it will not produce addressable effects when connected to non-addressable RGB outputs. The 500 mm length is intended for short to medium runs—longer layouts may require multiple strips or alternative solutions to avoid uneven illumination.

Key specifications

• Length: 500 mm
• Connector orientation: 90-degree (right-angle) connector
• Lighting type: Addressable RGB (ARGB)
• Daisy-chain: Supports chaining multiple strips for synchronized control
• Intended use: Internal PC case lighting and custom lighting setups

How to use

Mount the LED strip inside the PC case on a clean, dry surface following the manufacturer’s mounting recommendations. Connect the strip to an ARGB-compatible header or controller using the right-angle connector; if chaining additional strips, connect them in sequence using the daisy-chain connector. After physical installation, configure lighting zones and effects using the motherboard or controller software to achieve desired addressable patterns and synchronization.

What to consider before purchase

• Ensure your motherboard or controller supports addressable RGB (ARGB) headers and the required voltage and pinout.
• Confirm the 500 mm length fits your planned installation location inside the case.
• Plan for the number of strips to chain and available controller ports or power limits to maintain consistent brightness and effects.

Recommendations

For clean installation, route the right-angle connector along case edges or behind components to minimize visible cabling. When chaining multiple strips, test lighting and signal before final adhesive placement to confirm correct orientation and effect synchronization.