Ugello Creality per Ender-3 V3 SE — alta portata (ricambio, MPN 4007010127)

Replacement nozzle engineered for the Creality Ender-3 V3 SE series, specified as a high flow rate nozzle to support increased filament throughput. This nozzle is intended for routine maintenance and part replacement after wear, clogging, or when higher extrusion rates are needed for larger layers or faster print speeds. It is compatible with standard heater block and hotend assemblies used in the Ender-3 V3 SE and designed to maintain consistent melt flow while reducing back pressure during high-speed extrusion.

Advantages

The high flow design enables faster extrusion and improved material flow for larger layer heights and high-speed printing without significantly compromising dimensional accuracy. Precision machining ensures a consistent internal geometry that reduces the likelihood of partial clogs and maintains stable flow at elevated feed rates. The nozzle’s thermal mass and finish are chosen to provide repeatable heat transfer and smooth filament passage, supporting consistent surface quality when printing at increased speeds.

Suitable for

• Users upgrading print speed or layer height on Ender-3 V3 SE
• Routine maintenance to replace worn or partially clogged nozzles
• Printing larger functional parts where faster material deposition is needed
• High-speed prototyping where reduced print time is a priority

Key specifications

• Nozzle type: high flow rate geometry for increased filament throughput
• Compatibility: designed for Creality Ender-3 V3 SE hotend/heater block systems
• Material: corrosion-resistant metal suitable for common filaments
• Finish: smooth internal surface to reduce friction and minimize clogging
• Thermal behaviour: optimized for stable heat transfer during higher extrusion rates

How to use

Power off the printer and allow the hotend to cool before disassembly. Heat the hotend to a temperature appropriate for the filament previously used, then remove the existing nozzle using a suitable wrench while holding the heater block to prevent twisting the hotend assembly. Install the replacement nozzle by threading it into the heater block by hand until snug, then heat the hotend and perform a final torque while hot to ensure a secure seal. After installation, recalibrate first-layer height and adjust flow rate or extrusion multiplier as needed to account for the increased throughput.

Recommendations

For best results, verify nozzle diameter and re-slice models to suit larger layer heights and faster speeds. Perform test prints to fine-tune temperature and flow settings for each filament type. Regularly inspect and clean the nozzle to maintain consistent high-flow performance, and avoid abrasive filaments without appropriate wear-resistant nozzle variants.