Ugello hotend Flashforge Creator 4 unità ugello sinistra-HS 0,6 mm

The Flashforge Creator 4 Left Nozzle Assembly-HS (0.6mm) is a spare hotend nozzle designed for use with the Flashforge Creator 4 3D printer. Manufactured in China, this 0.6 mm high‑shear (HS) nozzle provides controlled filament flow and supports precise deposition for a range of printing materials and detailed models.

Advantages

This 0.6 mm HS left nozzle offers consistent extrusion, improved layer accuracy and reliable compatibility with the Flashforge Creator 4. Its design helps maintain steady material flow at typical printing temperatures and contributes to repeatable print quality for both prototypes and functional parts.

Suitable for

• Printing medium- to high-detail models where a 0.6 mm orifice is required
• Functional parts that require reliable extrusion and dimensional stability
• Replacement or spare nozzle for Flashforge Creator 4 users

Key specifications

• Compatibility: Flashforge Creator 4 (Left nozzle)
• Nozzle type: Hotend nozzle, HS variant
• Orifice diameter: 0.6 mm
• Manufacturer part number (MPN): 20002955001
• EAN: 6971940409342
• Country of origin: China

How to use

Before installation, allow the printer hotend to cool and follow the manufacturer's instructions for nozzle removal and replacement. Heat the hotend to the appropriate temperature for the previously used filament to safely remove the old nozzle, then install the Flashforge Creator 4 Left Nozzle Assembly‑HS (0.6mm) and tighten according to the printer's service procedure. After installation, calibrate the printer's nozzle offset and run a test print to verify extrusion and dimensional accuracy.

Recommendations

Use the 0.6 mm HS nozzle for prints that benefit from slightly faster extrusion and stronger per-layer adhesion compared with finer nozzles; adjust print settings (temperature, flow rate, layer height and print speed) to suit the material and desired surface detail.