AWTOOLS saldatrice per tubi in plastica 2000W per PVC PP PE PB PVDF PPR 20-63mm con 6 ugelli in PTFE, supporto, utensile da taglio, guanti, valigetta

Where basic heating tools choke on larger diameters, the AWTOOLS 11013599 plastic pipe welder keeps its cool—or rather, its heat—steady and even across the full 20–63 mm range. Built around a 2000 W aluminum heating plate and six PTFE-coated dies, it fuses PVC, PP, PE, PB, PVDF, and PPR pipe with clean, repeatable socket joints. The thermostatic dial spans 0–300 °C, so you can match the exact melting point of the material in hand, while the heat-resistant handle and ready-light feedback keep the workflow fast and safe on any job site.

Highlights

• 2000 W heating power for fast warm-up and consistent fusion
• Accepts pipe diameters from 20 mm to 63 mm
• Six non-stick PTFE-coated dies included: 20, 25, 32, 40, 50, 63 mm
• Adjustable thermostat from 0 °C to 300 °C for precise material handling
• Compatible with PP, PE, PB, PVDF, PPR, and PVC pipes
• Ergonomic, heat-resistant handle for comfortable operation
• Heating and ready indicator lights for clear status feedback
• Aluminum heating plate distributes heat evenly across the die surface
• Supplied with metal stand, pipe cutter, measuring tape, screwdriver, Allen key, gloves, and metal carrying case

In daily use

The welder runs on a standard 230 V, 50 Hz mains supply, so it fits into most European job sites without special power requirements. Set the desired temperature on the thermostatic dial, wait for the ready light, and then press the pipe and fitting onto the corresponding dies. The PTFE coating releases the workpiece cleanly after each joint, and the included stand keeps the hot plate stable while you reposition. When the job is done, everything packs into the metal carrying case—cutter, tape, gloves, and all.

Full specifications

• Power output: 2000 W
• Operating voltage: 230 V AC
• Frequency: 50 Hz
• Pipe diameter capacity: 20–63 mm
• Temperature range: 0–300 °C
• Number of heating dies: 6
• Included die sizes: 20, 25, 32, 40, 50, 63 mm
• Die coating: non-stick PTFE
• Welding type: socket fusion
• Compatible pipe materials: PP, PE, PB, PVDF, PPR, PVC
• Temperature control: thermostatic
• Heating indicator light: yes
• Ready indicator light: yes
• Heating plate material: aluminum
• Handle type: ergonomic, heat-resistant
• Included accessories: metal stand, pipe cutter, measuring tape, screwdriver, Allen key, gloves, metal carrying case

Final note

From tight repair cavities to open trench work, this AWTOOLS welder gives you the heat, the dies, and the carrying case to move from one fusion to the next without missing a beat.