BlueOptics JW090A-BO modulo ricetrasmettitore di rete in fibra ottica SFP+ LC alluminio 20 g

The BlueOptics JW090A-BO network transceiver module Fiber optic SFP+ LC Aluminium 20g is a compact SFP+ optical transceiver designed for 10 Gbps data links using LC duplex connectors and multimode fiber. Constructed with an aluminium housing and weighing approximately 20 g, this module follows industry MSA form-factor standards and is intended for integration into network switches, routers and other compatible networking equipment that accepts SFP+ transceivers.

Advantages

The module provides a small-form-factor solution for 10G optical connectivity with an LC connector and aluminium casing for mechanical durability and thermal dissipation. Its SFP+ interface supports high-speed Ethernet and other protocol transport over multimode fiber while remaining compatible with standard SFP+ ports. The lightweight build simplifies handling and installation in dense rack environments.

Suitable for

• 10 Gigabit Ethernet links over multimode fiber
• Interconnecting switches and routers in data center or enterprise networks
• High-speed uplinks between network devices
• Replacement or upgrade of existing SFP+ transceivers with LC interface

Key specifications

• Form factor: SFP+
• Connector type: LC duplex
• Housing material: aluminium (silver/aluminium colour)
• Typical weight: 20 g
• Designed for multimode fiber optical links
• Supports 10 Gbps class applications

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on your switch, router or transceiver-capable device until it locks into place. Connect an LC duplex multimode fiber patch cable to the module's LC connector, observing correct transmit/receive orientation. Ensure the host device is configured to recognize and enable the SFP+ interface; verify link status and speed through device management interfaces. Remove the module by disengaging any retention mechanism and pulling the module straight out by its extraction tab.

Recommendations

Use high-quality multimode LC patch cords and follow the host vendor’s guidance for supported transceiver firmware and DDM/DOM support. Avoid touching fiber endfaces, keep dust caps on when not connected, and install modules in accordance with recommended ambient temperature and handling procedures to maintain link performance and module lifetime.