Modulo ricetrasmettitore di rete CBO 57-1000076-01-BO SFP+ 10 Gbit/s 1310 nm

CBO 57-1000076-01-BO SFP+ 10 Gbit/s 1310 nm is a hot-pluggable fiber-optic transceiver module designed for 10 Gbit/s Ethernet and other high-speed optical links. The module operates at a nominal wavelength of 1310 nm and is intended for short- to medium-range single-mode fiber connections. It fits into standard SFP+ ports on switches, routers and servers to provide interoperable, low-latency connectivity in data center and enterprise environments.

Advantages

The transceiver provides a compact SFP+ form factor that supports 10 Gbit/s line rates and offers plug-and-play installation without powering down equipment. Its 1310 nm wavelength is suitable for reliable single-mode transmission over typical campus and metro spans. The module is designed for industry-standard compatibility, enabling fast replacement and straightforward integration with existing fiber infrastructure while maintaining consistent signal quality.

Suitable for

• 10 Gbit/s uplinks between switches and aggregation devices
• Server connections in data center racks
• Short- to medium-reach single-mode fiber links within campus and enterprise networks
• Interconnecting routers and firewalls with optical ports

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbit/s
• Wavelength: 1310 nm
• Optical fiber type: Single-mode fiber (SMF)
• Typical reach: short to medium range over single-mode fiber
• Interface: LC duplex optical connector compatible
• Operating environment: standard data center and enterprise conditions

How to use

Install the transceiver into an available SFP+ slot on your network device until it latches; no tools are required. Connect the LC duplex single-mode fiber cable to the module, observing correct transmit/receive orientation. After insertion and cable connection, verify link status and speed in your switch or server management interface. For hot-swap replacement, safely remove the module by unlatching and pulling it straight out, then insert the replacement while the device remains powered if supported.

Recommendations

Use clean, undamaged LC connectors and follow fiber handling best practices to maintain signal quality. Ensure compatibility of optical budget and link distance with installed single-mode fiber. Store unused modules in protective dust caps and anti-static packaging.