Modulo SFP+ in fibra ottica CBO 407-10357-BO, 10 000 Mbit/s, 300 m

BlueOptics Fiber optic SFP+ module CBO 407-10357-BO is a compact network transceiver designed to deliver 10 000 Mbit/s over multimode or single-mode fiber up to 300 m. The module fits standard SFP+ slots and is intended for high-speed uplinks between switches, routers and servers. Its form factor and electrical interface follow industry SFP+ specifications to ensure interoperability with compatible network equipment and straightforward integration into existing infrastructures.

Advantages

This SFP+ fiber module provides a stable 10 Gbit/s data rate with low latency and predictable throughput, suitable for demanding network environments. The small, hot-pluggable SFP+ form factor allows easy upgrades or replacements without powering down devices. Built to common optical standards, the module supports reliable links over distances up to 300 m, simplifying consolidation of data center and enterprise network connections.

Suitable for

• High-speed uplinks between switches and routers
• Server-to-switch 10 Gbit connections in data centers
• Enterprise network aggregation and distribution links
• Upgrading network ports to 10 Gbit/s without chassis changes

Key specifications

• Data rate: 10 000 Mbit/s (10 Gbit/s)
• Maximum link distance: up to 300 meters over appropriate fiber
• Connector type: SFP+ form factor compatible
• Optical medium: supports multimode and single-mode fiber where applicable
• Hot-pluggable design for in-service installation and replacement

How to use

Insert the SFP+ module into an available SFP+ slot on a switch, router or server network interface and secure it according to the host device instructions. Connect the appropriate fiber patch cable to the module's optical port, ensuring correct fiber type and polarity. Verify link negotiation and speed via the device management interface; the module is intended to operate at 10 000 Mbit/s when both ends support the same speed. For safe removal, disable the port or follow the host equipment's hot-swap procedure before extracting the module.

Recommendations

Use factory-terminated fiber patch cords matching the module's fiber type and connector to maintain signal integrity. Ensure transceiver compatibility with host equipment and check device firmware recommendations. Keep optical connectors clean and capped when not in use to prevent contamination and signal degradation.