Ricetrasmettitore CBO SFP-10G-BX-U fibra ottica 10G singlemode modulo SFP+

CBO SFP-10G-BX-U Fiber Optic 10G single‑mode SFP+ module is a compact optical transceiver engineered for 10 Gigabit Ethernet links over single‑mode fiber. The module fits standard SFP+ ports and supports hot‑swap operation, enabling fast replacement or upgrade without powering down equipment. It is suitable for point‑to‑point uplinks and long-reach connections in data centers, campus backbones and carrier networks where single‑mode fiber is used.

Advantages

The module provides 10G data throughput with a small form factor compatible with SFP+ interfaces, offering low latency and stable optical performance for high-bandwidth links. Hot‑swap capability reduces maintenance windows and simplifies field replacement. Designed for interoperability, it works with a broad range of switches and routers that accept standard SFP+ transceivers. The single‑mode design enables long‑distance transmission while maintaining signal integrity.

Suitable for

• Data center uplinks between top-of-rack or aggregation switches
• Campus and enterprise backbone fiber links
• Carrier and metro networks requiring 10G single‑mode connectivity
• Inter-switch links and router uplinks with SFP+ ports

Key specifications

• Form factor: SFP+ (compact hot-pluggable transceiver)
• Data rate: 10 Gigabit Ethernet
• Optical type: single‑mode fiber
• Wavelength: typical for single‑mode 10G optics (device-specific)
• Connector: LC duplex compatible
• Operation: hot‑swap capable for in-service replacement
• Typical applications: long-reach fiber links for uplinks and backbones

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on the switch or router until it latches. Connect LC‑terminated single‑mode fiber patch cords to the transmit and receive ports, observing correct polarity. After insertion, verify link status via the host device LEDs or management interface and check that the link negotiates at 10G. For removal, power‑down is not required in most systems; press the module latch and gently pull the transceiver out following the equipment manufacturer’s instructions.

Recommendations

Use quality single‑mode LC patch cords and maintain proper fiber handling to avoid contamination. Confirm compatibility with your network equipment and firmware requirements before deployment. Store unused modules in protective anti‑static packaging and avoid exposing optical ports to dust or direct sunlight.