Ricetrasmettitore ottico CBO SFP-10G-BX-U 10G, 1310 nm

CBO SFP-10G-BX-U is a 10 Gigabit single‑mode optical transceiver operating at a wavelength of 1310 nm. Intended for use in SFP ports of network switches, routers and telecom equipment, this module supports full 10G data throughput for short- to medium-range fiber links. The compact hot‑swappable design allows insertion and removal without powering down the host device, simplifying upgrades and maintenance of fiber networks.

Advantages

The transceiver delivers 10 Gigabit performance over single‑mode fiber with a stable 1310 nm optical interface and low jitter. Its small form factor and hot‑swap capability minimize downtime when replacing or upgrading modules. Built to industry physical and electrical standards, the module ensures compatibility with a wide range of networking hardware that supports SFP optics.

Suitable for

• 10G single‑mode fiber links between switches and routers
• Aggregation and uplink ports in data center and enterprise networks
• Telecom access and metro network segments with medium reach
• Equipment upgrades where hot‑swappable 10G optics are required

Key specifications

• Data rate: 10 Gigabit Ethernet
• Wavelength: 1310 nm
• Fiber type: single‑mode
• Form factor: SFP (small form‑factor pluggable)
• Reach: suitable for short to medium optical distances on single‑mode fiber
• Interface: duplex LC connector
• Power and signaling: standard SFP electrical interface for hot‑swap operation

How to use

Insert the module into a compatible SFP port on the powered device until it seats securely; the host will detect the transceiver automatically. Connect single‑mode fiber cables with matching LC duplex connectors, observing correct transmit/receive alignment. Monitor link status via the host device's management interface and verify optical power and signal integrity when commissioning. Remove the module by releasing any latch or retaining mechanism and pulling it straight out; perform swaps while following the equipment manufacturer's hot‑swap guidelines.

Recommendations

Use clean, undamaged single‑mode fiber with properly polished LC connectors to maintain signal quality. Verify compatibility with the host device's supported optical modules and check link budget requirements for the intended distance. Avoid bending fiber beyond recommended radii and protect the transceiver from electrostatic discharge during handling.