Ricetrasmettitore SFP+ CBO AA1403015-E6-BO 10.000 Mbit/s LC SR 300 m

The CBO SFP+ Transceiver AA1403015-E6-BO 10,000 Mbit/s LC SR 300 m is a compact fiber-optic module engineered for 10 Gigabit Ethernet links. It uses an LC duplex connector and supports short-range multimode fiber transmission up to 300 meters, making it suitable for connections inside data centers, server rooms and campus networks. The transceiver provides a standard SFP+ form factor to ensure compatibility with a wide range of switches, routers and network interface cards that accept hot-pluggable modules.

Advantages

This SFP+ transceiver offers a reliable 10,000 Mbit/s data rate with low latency and stable optical performance for short-range links. Its LC connector and SFP+ footprint allow easy installation and replacement without powering down network equipment. The module is designed to deliver predictable signal integrity over multimode fiber up to 300 m, helping maintain efficient traffic flow between servers, switches and storage devices.

Suitable for

• 10 Gigabit Ethernet links in data centers and server rooms
• Inter-switch connections within the same building or campus
• High-speed uplinks between aggregation switches and core switches
• Short-range fiber connections for storage area networks (SAN)

Key specifications

• Data rate: 10,000 Mbit/s (10 Gb/s)
• Connector: LC duplex
• Transmission type: Short Range (SR) over multimode fiber
• Maximum reach: up to 300 meters
• Form factor: SFP+ (hot-pluggable)
• Typical application: 10 GbE links between switches, servers and storage

How to use

Insert the transceiver into a compatible SFP+ slot on your switch, router or network card until it clicks into place. Connect LC duplex multimode fiber patch cords to the module, observing correct transmit/receive orientation. After installation, verify link status and speed on the host device and configure network settings as required. For removal, release the module latch and gently pull the transceiver out while following ESD and handling precautions.

Recommendations

Use multimode fiber cabling that meets industry standards (OM3/OM4) to achieve the specified 300 m reach. Keep dust caps on connectors when the module is not in use, and follow proper electrostatic discharge (ESD) handling procedures during installation. Verify compatibility with your network hardware and firmware to ensure full functionality of the SFP+ transceiver.