Ricetrasmettitore SFP+ CBO SFP-10G-BX-U-40KM-CP-BO 10 Gbit/s LC monomodale, 40 km

The CBO SFP-10G-BX-U-40KM-CP-BO is an SFP+ optical transceiver module that supports 10 Gbit/s data rates over single-mode fiber with an LC connector and a maximum link distance of 40 km. Built for high-speed uplinks and metro network segments, this compact, hot-pluggable module enables duplex communication over a single fiber strand using wavelength-division techniques and fits standard SFP+ ports for straightforward integration into switches, routers and optical equipment.

Advantages

This transceiver provides reliable long-distance connectivity at 10 Gbit/s while minimizing fiber infrastructure by supporting bidirectional data transmission on one single-mode fiber. The LC interface ensures broad compatibility with common fiber patching systems, and the hot-pluggable design allows replacement or upgrades without powering down equipment. The module’s form factor and electrical characteristics conform to SFP+ standards for predictable interoperability with supporting network devices.

Suitable for

• 10 Gbit/s uplinks between switches and aggregation points
• Metro and MAN links where single-fiber duplex is preferred
• Data center spine-to-leaf connections over single-mode fiber
• Long-distance point-to-point optical links up to 40 km

Key specifications

• Data rate: 10 Gbit/s
• Fiber type: single-mode
• Connector: LC duplex (single-fiber bidirectional use)
• Maximum reach: up to 40 km (single-mode)
• Form factor: SFP+ hot-pluggable
• Duplex method: bidirectional (wavelength-division on single fiber)

How to use

Insert the transceiver into an SFP+ port on a powered network device until it clicks into place, then connect the single-mode fiber with LC connectors following the device vendor’s port labeling for transmit and receive wavelengths. Configure the network interface settings on the host device as required for 10 Gbit/s operation and link negotiation, and verify link status through the device management interface. To remove, power down the port if recommended by the equipment vendor or follow hot-swap instructions, then gently pull the module from the cage.

Recommendations

Install and handle the module in a clean environment to avoid contamination of fiber connectors, use compatible single-mode fiber cabling, and check device compatibility and supported SFP+ transceiver lists from the equipment vendor to ensure correct operation. Observe ESD precautions during handling and store unused modules in protective packaging.