Ricetrasmettitore SFP+ CBO SFP-10G-ER 10G 40 km modulo ottico

The BlueOptics SFP-10G-ER is an SFP+ optical transceiver supporting 10 Gbit/s data rate with a transmission reach of up to 40 km. Designed for long-reach 10G Ethernet links, this pluggable module provides a standardized electrical and optical interface for switches, routers and optical equipment. The module is suitable for metro and campus backbone links where single-mode fiber and extended distance are required, offering hot-pluggable convenience and straightforward replacement without system downtime.

Advantages

The SFP+ Transceiver CBO SFP-10G-ER delivers a compact form factor and compatibility with equipment supporting SFP+ ports, enabling high-density deployment in racks and chassis. With support for 10 Gbit/s signaling and single-mode fiber reach up to 40 km, it meets the requirements of long-distance Ethernet connections while maintaining low power consumption and stable optical performance. The pluggable design simplifies maintenance and upgrades by allowing non-disruptive swaps.

Suitable for

• Long-reach 10G Ethernet links over single-mode fiber
• Metro, campus and enterprise backbone connectivity
• Interconnection between data center racks or buildings
• Redundant fiber paths and link aggregation for increased capacity

Key specifications

• Data rate: 10 Gbit/s (SFP+ compatible)
• Maximum reach: up to 40 km over single-mode fiber
• Optical interface: SFP+ pluggable module for single-mode fiber
• Wavelength: suitable for extended-reach transmission (single-mode)
• Form factor: SFP+ small form-factor pluggable
• Power consumption: low-power design suitable for high-density deployments
• Connector type: LC duplex

How to use

Install the SFP+ Transceiver into an available SFP+ slot on a compatible switch, router or optical device while the host equipment is powered on if the device supports hot-plugging. Connect single-mode LC duplex fiber patch cords to the module, ensuring correct transmit and receive alignment. Configure link settings on the host device as required for 10 Gbit/s operation. Replace or remove the module by gently extracting it from the port; follow the host vendor instructions to avoid damage during handling.

Recommendations

For reliable long-distance performance, use ITU-T-compliant single-mode fiber with appropriate attenuation budget and clean LC connectors. Verify optical power and receiver sensitivity compatibility when planning links near the module's maximum reach. Keep the module free of dust, store spare modules in anti-static packaging, and follow vendor guidance for firmware or compatibility lists if using third-party optics in branded equipment.