Ricetrasmettitore SFP+ CBO SFP-10G-ER-NV-BO, 10 Gbit/s 10 km monomodale

CBO SFP-10G-ER-NV-BO is an SFP+ optical transceiver that supports a 10 Gbit/s data rate over single‑mode fiber. Engineered for links of up to approximately 10 km, this hot‑pluggable module provides a compact interface for 10G Ethernet and compatible communication standards. The module is intended for installation in SFP+ ports on switches, routers and media converters to extend uplinks or create reliable point-to-point connections in data centers and telecom environments.

Advantages

The transceiver delivers 10 Gbit/s throughput with single‑mode optical performance suitable for short metropolitan and campus links up to about 10 km. Its hot‑pluggable SFP+ form factor allows replacement or upgrades without powering down network equipment. The module is compatible with common 10G Ethernet implementations and supports straightforward insertion into standard SFP+ cages. Compact dimensions and low power consumption make it suitable for dense rack installations where space and thermal budgets are constrained.

Suitable for

• Extending 10G Ethernet uplinks between switches and routers over single‑mode fiber
• Connecting aggregation switches in data center and campus networks
• Establishing point-to-point fiber links for telecom access and distribution
• Replacing or upgrading existing SFP+ modules in network devices

Key specifications

• Data rate: 10 Gbit/s
• Fiber type: single‑mode fiber (SMF)
• Maximum link distance: approximately 10 km
• Form factor: SFP+ hot‑pluggable transceiver
• Typical use: 10G Ethernet and compatible high‑speed serial interfaces
• Connector type: LC duplex
• Operating temperature: industry‑standard commercial range (refer to device documentation for exact limits)

How to use

Insert the SFP+ transceiver into an available SFP+ cage on a switch, router or media converter while the host supports 10 Gbit/s operation. Ensure the module is fully seated and that any retention mechanism latches. Connect LC duplex single‑mode fiber cables with correct polarity between link endpoints and verify link status via the host device management interface. If required, configure the device port for 10G full‑duplex operation and monitor link diagnostics provided by the host equipment.

Recommendations

To ensure reliable operation, use single‑mode fiber with appropriate attenuation and patching practices, maintain correct connector cleanliness, and observe manufacturer guidelines for operating temperature and power budget. When replacing modules, confirm host compatibility and firmware settings to avoid link negotiation issues.