Ricetrasmettitore SFP CBO SFP-1G-EX-LE-BO 40.000 Mbit/s

CBO SFP-1G-EX-LE-BO is an SFP transceiver designed for optical networking equipment with SFP slots, delivering data rates up to 40,000 Mbit/s. It provides a compact, hot-pluggable interface for uplink and interconnect links, allowing network administrators to expand port capacity, upgrade link performance, or replace faulty modules without replacing switches or routers. The module is compatible with devices that support standard SFP transceivers and is suitable for use in data centers, aggregation sites and enterprise networks.

Advantages

The transceiver offers high data throughput in a small form factor, supporting fast link upgrades while minimizing space and power requirements. Its hot-pluggable design simplifies maintenance and replacement, reducing downtime during hardware swaps. Built to industry SFP form-factor standards, it provides broad compatibility with networking equipment that accepts standard SFP modules. The module's optical interface supports long-reach connections suitable for uplinks between racks or buildings.

Suitable for

• Expanding switch or router uplink ports
• Upgrading link capacity in aggregation and core layers
• Replacing defective SFP modules in installed equipment
• Optical interconnects in data center racks and wiring closets

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data rate: up to 40,000 Mbit/s
• Interface type: optical SFP transceiver
• Hot-pluggable: yes
• Typical applications: uplink, interconnect, port expansion

How to use

Install the transceiver by inserting it into an available SFP slot on a compatible switch, router or media converter until it clicks into place. Connect the appropriate optical fiber cable to the module's optical interface, ensuring correct connector type and polarity. Verify link status through the host device's management interface and confirm negotiated speed and operational state. To remove, power down the host port if recommended by the equipment vendor, then gently pull the module from the SFP slot using the module's release latch or tab.

Recommendations

Use factory-tested optical cables and follow device vendor guidelines for cable types, connector polishing and cleaning to ensure reliable optical links. Observe ESD precautions when handling the module and cap the optical connectors when not in use. For critical links, monitor signal status and consider redundant paths to maintain availability.