Ricetrasmettitore SFP+ in fibra ottica CBO IB-000180 10Gbps

The Fiber Optic SFP+ Transceiver CBO IB-000180 10Gbps is a small-form pluggable module for establishing 10 Gigabit optical links in compatible SFP+ network equipment. Designed for use with switches, routers and servers that accept SFP+ modules, this transceiver enables high-speed data transfer over fiber, extending network reach and providing low-latency connections suitable for data center and enterprise LAN environments.

Advantages

This SFP+ transceiver supports a 10Gbps data rate and is built for compatibility with standard SFP+ ports, offering a compact, hot-pluggable solution that simplifies installation and replacement. The optical interface reduces electrical interference and supports stable high-bandwidth communication, while the module’s form factor allows flexible deployment across different network devices without modifying existing hardware.

Suitable for

• High-speed uplinks between switches and aggregation points
• Server connections in rack and blade environments
• Data center interconnects and campus backbone links
• Enterprise LAN segments requiring low-latency fiber connections

Key specifications

• Interface type: SFP+ small form-factor pluggable
• Nominal data rate: 10 Gbps
• Medium: optical fiber transmission
• Form factor: hot-pluggable transceiver module
• Typical applications: short- to medium-reach fiber links in network infrastructure

How to use

Install the transceiver into a compatible SFP+ port on the network device until it clicks into place; the device should recognize the module automatically if firmware and hardware compatibility are met. Connect appropriate fiber patch cords to the transceiver’s optical interface, ensuring correct single-mode or multi-mode fiber type and connector polarity as required by your network design. Verify link status through the host device’s indicators and management interface and, if necessary, configure link parameters such as speed and duplex on the connected devices.

Recommendations

Prior to deployment, confirm compatibility with the target switch, router or server and use fiber cabling that matches the module’s optical specifications. Handle the transceiver by the housing, avoid touching the optical interface, and keep dust caps on when the module is not in use. For reliable operation, monitor link status and perform firmware or driver updates for host devices when recommended by the hardware vendor.