Cavo AOC BlueOptics AOC-Q-Q-40G-1M-BO 1m QSFP connettore maschio/connettore maschio

The BlueOptics AOC-Q-Q-40G-1M-BO is a 1‑metre active optical cable with QSFP connectors on both ends, engineered for high‑speed data transmission in data centres and enterprise networks. This cable supports 40 Gbps class links and provides a compact, low‑latency interconnect between switches, routers and servers where short‑reach, high‑bandwidth connections are required.

Advantages

This active optical cable combines the signal integrity of optical transmission with plug‑and‑play QSFP connectivity, eliminating the need for separate transceivers. The short 1 m length reduces clutter and simplifies cable management in dense rack environments. Designed for low power consumption and stable performance, it supports high throughput with reduced electromagnetic interference compared to copper alternatives.

Suitable for

• Short‑reach links between network switches and aggregation devices
• High‑performance server interconnects in racks and chassis
• Top‑of‑rack connections in data centres
• Interconnects in virtualised or high‑density networking setups

Key specifications

• Connector type: QSFP (QSFP+ compatible form factor)
• Length: 1 metre
• Data rate: designed for 40 Gbps class links
• Optical technology: active optical cable (AOC)
• Cable form factor: direct attached with fixed connectors at both ends
• Typical application: short‑reach, high‑bandwidth interconnects in racks and equipment

How to use

Install the BlueOptics AOC‑Q‑Q‑40G‑1M‑BO by inserting each QSFP connector into the corresponding QSFP port on your network devices, ensuring the connector latch engages. No separate driver or transceiver module is required; the cable is recognised by equipment that supports QSFP AOC links. Verify link status through the device management interface and ensure firmware and port settings (speed/encapsulation) match the intended 40 Gbps operation.

Recommendations

Route the cable to avoid sharp bends and mechanical stress; maintain the manufacturer’s minimum bend radius. Use in environments where short, high‑bandwidth optical links are needed and verify compatibility with equipment QSFP port types and firmware for optimal operation.