Cavo di alimentazione AIRTAME AT-IEC IEC 60320 C7, lunghezza 1,8 m

AIRTAME AT-IEC power cable with an IEC 60320 C7 connector and a 1.8 m length provides a standard mains connection for devices with a figure‑8 (C7) inlet. The cable is intended for general-purpose use with small AV equipment, chargers and media devices where a reliable, uncomplicated power link and modest reach are required. Its 1.8 metre length is suitable for most desktop and wall‑mounted installations without excessive slack.

Advantages

The cable uses a conventional IEC 60320 C7 connector that fits many consumer electronics and AV devices, ensuring compatibility with common power inlets. Its 1.8 m length balances accessibility and tidy routing in typical office and home environments. The design prioritizes a secure, low-profile connection and straightforward plug‑and‑play setup without special adapters.

Suitable for

• Small audio/video equipment such as compact media players and soundbars
• Portable chargers and power supplies that use a figure‑8 inlet
• Desktop or wall‑mounted media devices with limited cable distance
• Replacement cable for compatible consumer electronics

Key specifications

• Connector type: IEC 60320 C7 (figure‑8)
• Length: 1.8 m
• Intended use: mains power connection for devices with C7 inlet
• Compatibility: small AV devices, chargers and media players with figure‑8 socket
• Cable configuration: two‑pole non‑polarised power lead

How to use

Insert the IEC 60320 C7 connector into the device's figure‑8 inlet until it seats securely, then plug the opposite end into a suitable mains socket. Ensure the mains voltage and frequency match the requirements of the connected device. Route the cable to avoid sharp bends, heat sources and areas where it may be pinched or tripped over. Disconnect the cable by pulling the plug — not the cable — and switch off the mains supply if necessary before connecting or disconnecting.

Recommendations

Use this cable only with devices that accept a C7 figure‑8 power lead and within the cable's current and voltage ratings as specified for your device. Inspect the cable periodically for damage and replace it if the insulation is compromised or connectors are loose. Avoid exposing the cable to liquids and avoid modifying or splicing the lead.