Cavo di rete LOGON SSTP Cat6a RJ-45 RJ-45 2 m blu

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable (2 m, blue) is built for high-speed wired Ethernet connections. It complies with the Cat6a standard and features two shielded RJ45 male connectors, a boot with kink protection and strain relief, and a 1:1 EIA/TIA 568B wiring scheme to ensure predictable performance in home and office networks.

Advantages

Pairs with foil and full braid shielding provide improved protection against electromagnetic interference. The cable contains four twisted pairs (4 x 2 x AWG 26/7) with a characteristic impedance of 100 Ohm for stable signal transmission. Shielded RJ45 connectors and a reinforced boot with strain relief reduce wear at the connector ends and maintain reliable contact.

Suitable for

• High-speed Ethernet connections up to Cat6a performance
• Connecting switches, routers, NAS devices and PCs
• Office and home network installations requiring shielded cabling
• Short to medium length patching within structured cabling

Key specifications

• Cable type: SSTP (foil + full braid shielding)
• Pairs: 4 x 2 x AWG 26/7, twisted pair
• Characteristic impedance: 100 Ohm
• Connectors: 2 x shielded RJ45 male
• Wiring: 1:1 — EIA/TIA 568B
• Length: 2 m
• Colour: Blue

How to use

Plug each RJ45 connector into the corresponding Ethernet ports on your devices (switch, router, computer or NAS). Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid sharp bends; the boot with kink protection helps reduce strain but keep bends gentler than the cable diameter to preserve performance.

Recommendations

For optimal performance, use the cable for shielded network segments and avoid running it parallel to high-voltage power lines. Verify that connected devices and network equipment support Cat6a speeds and shielded cabling to benefit from the SSTP construction.