Cavo di rete METZ CONNECT 141N113K13K50 10 m Cat6 S/FTP giallo

The METZ CONNECT 141N113K13K50 is a 10-meter Cat6 networking cable with S/FTP shielding and factory-terminated RJ-45 connectors. Designed for structured cabling and point-to-point connections, this yellow cable provides reliable Gigabit-class performance and easy visual identification in patch panels, office floors or equipment racks. The Cat6 specification and foil/braid shielding reduce crosstalk and external electromagnetic interference to support stable high-speed data transfer.

Advantages

The S/FTP construction combines an overall foil shield with individually shielded pairs to offer enhanced protection against near-end crosstalk and external noise. Factory-terminated RJ-45 plugs ensure consistent pinout and low connection loss without the need for onsite crimping. The 10 m length covers common distances between desks and network equipment while the yellow jacket aids quick cable tracing and organization.

Suitable for

• Gigabit Ethernet connections in offices and small data closets
• Connecting switches, routers, patch panels and wall outlets
• Environments with potential electromagnetic interference
• Structured cabling where color-coded identification is required

Key specifications

• Category: Cat6
• Topology: S/FTP (overall foil with individually shielded pairs)
• Length: 10 m
• Connector type: RJ-45 on both ends, factory-terminated
• Color: Yellow
• Suitable for speeds: Up to Gigabit Ethernet (1000 Mbps) and compatible with standard Cat6 deployments
• Typical use: Horizontal cabling, patching and direct device connections

How to use

Route the cable between network devices or from patch panel to endpoint, avoiding sharp bends and tight loops that may stress the internal pairs. Insert the RJ-45 plugs fully into device or patch panel ports until the latch engages. For runs near sources of strong electromagnetic interference, maintain separation or use available cable routing conduits. No additional termination is required thanks to the factory-terminated connectors; verify link status on network equipment after connection.

Recommendations

For best performance, avoid bending the cable at radii smaller than the manufacturer's recommended minimum bend radius and avoid running the cable in parallel for long distances with high-voltage power lines. Use the yellow color for consistent labeling in patching schemes and replace if the outer jacket is damaged to preserve shield integrity.