Cavo di rete ShiverPeaks BS75720-G 10 m Cat6a S/FTP

The ShiverPeaks BS75720-G 10m Cat6a S/FTP networking cable is designed for high-speed wired Ethernet connections in home and professional environments. This cable supports Cat6a performance with individually shielded pairs and an overall foil shield (S/FTP) to reduce crosstalk and external electromagnetic interference. The cable is fitted with RJ-45 connectors and gold-plated contacts to maintain consistent signal transfer and corrosion resistance. Its 10 metre length and distinctive green jacket provide both reach and visual identification in patch panels, racks, or desktop setups.

Advantages

The S/FTP construction offers improved protection against near-end crosstalk and external noise compared with unshielded alternatives, helping maintain stable gigabit and 10GBASE-T links over the specified distance. Gold-plated contacts on the RJ-45 plugs improve conductivity and long-term reliability. The 10 m length covers typical room-to-room or equipment-to-switch connections while the visible green sheath simplifies cable management and identification in multi-cable installations.

Suitable for

• 10GBASE-T and Gigabit Ethernet connections in home or office networks
• Connecting switches, routers, NAS, and desktop computers
• Patching in server rooms, data closets, and structured cabling runs up to 10 metres
• Environments with potential electromagnetic interference where shielding is beneficial

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP — overall foil with individually shielded pairs
• Connector type: RJ-45 plugs
• Contact plating: Gold-plated contacts
• Length: 10 metres
• Jacket colour: Green
• Typical applications: 10GBASE-T, Gigabit Ethernet

How to use

Connect one RJ-45 plug to the Ethernet port of your network device (such as a switch, router, NAS, or computer) and the other plug to the corresponding port on the remote device. Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid tight bends and sharp edges that could stress the internal conductors or shielding. For installations in patch panels or racks, label each end if required for easier identification.

Recommendations

Position the cable away from high-voltage power lines and sources of strong electromagnetic interference where possible. Do not exceed the recommended bend radius printed by industry standards for Cat6a cables, and avoid stretching the cable during installation. Periodically inspect connectors for damage or corrosion and replace the cable if the jacket or shielding is compromised.