Cavo InfiniBand BlueOptics QSFP28-DAC-1M-VA-BL 1m connettore/connettore QSFP28

The BlueOptics QSFP28-DAC-1M-VA-BL InfiniBand Cable is a 1 meter passive direct attach twinax cable with QSFP28 male connectors at both ends, designed for short-range high-speed links in racks and between adjacent racks. It supports 100GBase-CR4 and InfiniBand applications up to 100 Gbps on a 1 m span and is MSA-compliant. The cable is intended for electrical signal transfer where a passive QSFP28 twinax solution is appropriate and is compatible with major hardware platforms that support QSFP28 direct attach copper links.

Advantages

This QSFP28 twinax cable provides a low-latency, low-power connection for high-throughput environments. As a passive DAC it requires no additional power for signal conversion and offers straightforward plug-and-play installation. The cable follows established mechanical and electrical MSA specifications for QSFP28 interconnects and uses high-quality components to ensure stable transmission and extended service life.

Suitable for

• Short-reach 100 Gigabit Ethernet links in data center racks
• InfiniBand high-performance computing interconnects
• Connections between switches, routers and storage systems within the same rack or adjacent racks
• Environments requiring low-latency, low-power cabling for server and network hardware

Key specifications

• Connector type: QSFP28 male to QSFP28 male
• Cable type: Passive twinax copper (DAC)
• Supported data rates: up to 100 Gbps
• Standard: 100GBase-CR4 / InfiniBand compatible
• Length: 1 meter
• Wire gauge: 30 AWG
• Compliance: MSA-compliant mechanical and electrical characteristics

How to use

Ensure both devices support passive QSFP28 direct attach copper cables and the target protocol (100GBase-CR4 or InfiniBand). Power down or follow hot-plug guidance from your hardware vendor if required, then insert the QSFP28 connectors into the appropriate transceiver slots until they latch. Verify link status in the device management interface and confirm negotiated speed and protocol. For removal, follow the vendor-specific release procedure to avoid mechanical stress on ports.

Recommendations

Use this 1 m passive QSFP28 DAC for short, direct rack-to-rack or in-rack connections where low latency and low power consumption are priorities. Avoid routing the cable near strong electromagnetic interference sources and maintain bend radii consistent with twinax copper installation best practices. Verify vendor compatibility when deploying in mixed-brand environments.