Cavo SFP+ BlueOptics SFP-AOC-10G-3M-PS-BO 3 m connettore maschio/connettore maschio

The BlueOptics SFP-AOC-10G-3M-PS-BO is a 3 meter SFP+ active optical cable (AOC) with SFP+ male connectors on both ends, designed for high-speed 10G data transmission over multimode fiber. Compliant with SFP+ AOC MSA physical and functional interfaces, this pre-assembled cable provides a direct optical link between SFP+ ports without the need for separate transceivers or patch cords. It is intended for use in data center and network environments where short-reach 10G connections are required and ease of installation and EMI immunity are important.

Advantages

This BlueOptics SFP+ Active Optical Cable offers a plug-and-play connection between SFP+ ports with integrated transmitter and receiver modules on each end, reducing the need for additional transceivers and fiber patching. The pre-assembled multimode optical link is not susceptible to electromagnetic interference and simplifies cable management. Its 3 m length is suitable for rack-to-rack or equipment-to-equipment connections inside data centers and network rooms, providing reliable 10G connectivity and digital diagnostic capability where supported by host hardware.

Suitable for

• Rack-to-rack 10G connections in data centers
• Switch-to-switch or switch-to-server 10G links
• High-throughput storage and SAN interconnects supporting SFP+
• Short-reach multimode fiber links within network cabinets

Key specifications

• Interface: SFP+ to SFP+ (male connectors)
• Length: 3 meters
• Type: Active Optical Cable (AOC)
• Transmission rate: up to 10 Gbps
• Fiber type: multimode (integrated optical transceivers)
• Compliance: SFP+ AOC MSA mechanical/electrical/functional agreement
• Digital diagnostics: DDM/DOM supported where host hardware provides support

How to use

Install the cable by inserting each SFP+ connector into compatible SFP+ ports on the devices to be connected, ensuring the latches engage and the connectors are fully seated. The cable is plug-and-play and does not require separate transceivers or fiber patching. Verify that the host devices support SFP+ AOC modules and, if needed, enable or check digital diagnostics through the device management interface. For best results, route the cable to avoid sharp bends and mechanical strain.

Recommendations

Use this 3 m BlueOptics SFP+ AOC for short-reach multimode links inside racks or between adjacent racks. Confirm host compatibility with SFP+ AOC modules and DDM/DOM support when remote monitoring is required. Avoid tight bends and excessive pulling force; store and route the cable in line with typical fiber optic handling practices.