Cavo ShiverPeaks 02014-25 cavo per diodi 2 x 0,14 mm² 25,0 m

ShiverPeaks 02014-25 diode cable is a 25.0 m long, two-conductor cable with each conductor sized at 0.14 mm². It is designed for low-voltage signal and diode connections where compact, flexible wiring is required. The insulated conductors provide reliable electrical paths for low-current applications and are suitable for indoor installations that demand thin, easy-to-route cabling.

Advantages

The cable combines a slim cross-section with flexibility to simplify routing in confined spaces and behind panels. Insulated conductors reduce the risk of short circuits when used with LED strips, sensors, or small control circuits. Its length allows for long runs without intermediate joints, minimizing points of failure. The construction is intended to support stable low-current signal transmission in household and light-commercial environments.

Suitable for

• LED strip connections and small LED modules
• Low-current sensor wiring and signal lines
• Control circuits for small appliances and switches
• Indoor installations behind panels, in cabinets, or along skirting

Key specifications

• Conductor count: 2 cores
• Conductor cross-sectional area: 0.14 mm² per core
• Length: 25.0 m
• Insulation: single insulated conductors suitable for low-voltage use
• Application voltage range: intended for low-voltage/low-current circuits (signal and diode connections)
• Flexibility: designed for routing in confined indoor spaces

How to use

Cut the cable to the required length and strip the insulation on each conductor carefully to expose the conductor without damaging strands. Connect conductors to the corresponding terminals of LEDs, sensors, or control modules, observing polarity where applicable. Secure and route the cable to avoid sharp bends and mechanical strain; use cable clips or adhesive channels if necessary. For permanent installations, ensure connections are properly insulated and, where applicable, protected by terminal blocks or shrink tubing.

Recommendations

Use this cable for indoor, low-voltage applications only. Avoid exposure to moisture, direct sunlight, or high temperatures. For higher currents or mains-voltage applications select an appropriately rated cable. When extending runs or joining cables, use reliable connectors and check continuity before powering the circuit.