CoreParts - DDR3L - Modulo - 4 GB - SO DIMM 204-PIN - 1600 MHz / PC3L-12800 - 1.35 V - unbuffered - non-ECC (MMG2494/4GB)

The CoreParts MMG2494/4GB is a 4 GB DDR3L memory module for laptops, operating at 1600 MHz. Supplied as a single SODIMM module (1 x 4 GB) with a green PCB, it is intended to upgrade or replace existing laptop RAM to improve multitasking and general system responsiveness while remaining compatible with DDR3L platforms.

Advantages

This memory module uses standard DDR3L technology at 1600 MHz for reliable performance and low-voltage operation. The single-module configuration makes it simple to add memory to a compatible laptop. The module's compact SODIMM form factor and tested chip sets ensure interchangeability with other DDR3L laptop modules.

Suitable for

• Laptops requiring DDR3L SODIMM memory
• Upgrading a system from 2 GB to 4 GB or adding an additional 4 GB module
• Replacing a faulty or incompatible 4 GB DDR3L module

Key specifications

• Capacity: 4 GB
• Memory type: DDR3L (low voltage)
• Clock speed: 1600 MHz
• Module configuration: 1 x 4 GB SODIMM
• Colour: Green PCB
• Weight: 0.02 kg

How to use

Power off the laptop and disconnect it from any power source. Open the memory compartment or remove the bottom cover according to the laptop manufacturer's instructions. Ground yourself to prevent static discharge, then locate the existing SODIMM slots. Insert the CoreParts DDR3L 4 GB module at a 30-degree angle into an empty or replacement slot until the retaining clips click into place. Reassemble the laptop and power it on; verify that the system recognizes the new memory in the BIOS/UEFI or operating system.

Recommendations

Install modules in matching pairs where supported by the laptop for optimal dual-channel performance. Ensure the laptop supports DDR3L 1600 MHz modules and the target capacity before installation. Handle the module by its edges and avoid touching the gold contacts.